Tons of Very Useful Scratch-building ~TIPS~

by Rcairplanenoob | November 12, 2013 | (0) Posted in Tips

Here is a whole bunch of very useful tips for the scratch-builder. Some of the tips are general, and some specifically apply to the flitetest swappable and ft elements series.

 

- Find this article & others like it at www.FliteTest.com -

Related Articles

Getting Started in Ultra Micro Scratch Builds

by Take2RC

Control Surfaces - Scratch Build Tips

by FliteTest

COMMENTS

eagle4 on November 18, 2013
Where did you get the glue mat?
Log In to reply
alibopo on November 18, 2013
Hi - you can also use silicone bakeware. I've a pie dish that I trimmed part of the side from - leaving most of the outer up-stand intact. My glue gun sits neatly in it - offering side protection as well as base protection. Same as the mat, the glue just peels away afterwards.
Log In to reply
Rcairplanenoob on November 18, 2013
I got it on ebay its an arttek i belive. Its the same brand as my gluegun
Log In to reply
Jaxx on November 20, 2013
Great Tips! You might want to try painter's tape to hold your plans down. It works well.
Log In to reply
Rcairplanenoob on November 18, 2013
I cane up with an awesome way to make hinges that ill post tonight. You squirt some glue on the nat and fold the mat in half and then trim the glue film to size. I used this on the bottom part of my um sukhoi tail (right above the wheel) it works amazing!
No strain on the servos at all!!
Log In to reply

You need to log-in to comment on articles.

Rcairplanenoob

(60)

Tons of Very Useful Scratch-building ~TIPS~