FT Simple Clip (3D printed)

by tophe75 | January 8, 2016 | (5) Posted in Projects

 The problem with flying RC is storing ALL your planes and other models.

As I really like the FT Swappable thing this came to be a problem when I was re-doing my sons room and needed a way to store his three models (Nutball, Flyer, Delta) so I turned to my own little factory, the 3D printer.

The idea was to make something like a clothespin and so the FT Simpe Clip was borne.

 The 3D file can be found on Thingivers (http://www.thingiverse.com/thing:1254575)

 Use a short but strong rubber band as you need the force to hold on to the pins of the plane.

 To hang it under the shelf I used the "Plane Hanger" (http://www.thingiverse.com/thing:39779) printed at 67%

COMMENTS

The-One-Who-Never-Crashes on January 8, 2016
Great to see you writing articles again! Welcome back :)
Log In to reply
jordy123 on January 13, 2016
Nice, will have to try( my mom says if I get 1 more plane, we'll need a new house!)
Log In to reply
guggyman123 on January 18, 2016
NIce article!
Log In to reply

You need to log-in to comment on articles.


FT Simple Clip (3D printed)