Specter V2 Foamboard Fuse Build Video

by spencer | July 12, 2013 | (0) Posted in Projects

I'm finally getting to this project, and for those that have been waiting for it I'm sorry for the delay.  Life has gotten in the way a little, with purchasing a new house and welcoming a new baby to our small family. 

Again a big thanks to IBCrazy for the design, and to Experimental Airlines for the inspiration on the wing.  And of course, all the people that drove this design to be made into a swappable, and Flitetest for coming up with the swappable series.

So, with no further delay, here it is.   

 I've added some photo's of the final product for those that would like more details.

 

 

 

 


This is the hatch that covers the nose.  I just taped down the back 4" to the fuselage and used a rubber band to hold it down.

 

If you have any questions on the details of this build, please don't hesitate to comment.  I will be following this up with a detailed photo article of the complete assembly of all the different parts. 

COMMENTS

wolfpackt99 on February 17, 2014
So the swappable series pod slides right in the back? I see it referenced and shown in other post but looks like receiver in the way. Also in wing build you say to increase to 1" and 2" spars. Based on the build video for the wing, should i just double the height? So instead of one fold do 4 sheet height in center and 2 sheet height near edge? Thanks. build commencing.
Log In to reply

You need to log-in to comment on articles.


Specter V2 Foamboard Fuse Build Video