A few days ago I broke two motor mounts on my x525. I needed a quick fix so I can fly again quickly. I went to local shop and they had only 1mm aluminium stripes witch are realy thin for motor mounts. My old GPU that i used for my battery mount still lying on my table. PCB from it is same thicknes as original mounts, but is much more stronger.
Video tutorial:
First of all i brutaly desoldered parts from PCB
Than i clean the surface with sand paper
Than i traced original mounts
Nex step was to cult them out and drill the holes
.
And there you have it, super stylish motor mounts. They are same thicknes and much more stronger.
I replaced only broken ones, but i will replace all in the future.
Thanks, i hope you liked it and dont forget to rate this artile.
Log In to reply
Really clever!
Log In to reply
Log In to reply
Log In to reply
Log In to reply
Log In to reply
Log In to reply
Log In to reply
Log In to reply