Easyglider Crash

This shows you how we crashed our 1 month old Multiplex Easyglider. 

Total Damage:
New fuselage, 2x HXT900 for ailerons, new spinner

Cause of crash:
We think the crash was caused by lack of attention of the spotters. The pilot was flying from a 9" LCD screen and had 2 spotters but at the moment of the crash both spotters weren't paying attention to the aircraft so no one could have taken over or recovered flight of the aircraft in any way. I hope this is a very important lesson to everyone who flies FPV. Always have at least 1 spotter paying attention to your aircraft or else bad things might happen :(

Setup on plane: 

- Recording camera: GoPro Hero 2 @ 1080p
- FPV camera: GoPro Hero 2 live feed
- Airframe: Multiplex Easyglider PRO
- Motor: NTM propdrive 35-30 1100kv / 380w (http://hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=39959)
- ESC:  35A non brand ESC
- Servo's: 2x HXT900 (ailerons) 2x Hitec HS-80 (Elevator and Rudder)
- Battery: Zippy 2200Mah 3S1P 40C
- Prop and Spinner: Staufenbiel 55mm Spinner, Aeronaut Carbon 12,6"x6"
- Tx & Rx: Spektrum DX6i DSMX with AR6210 with Sattelite reciever 
- FPV Tx & Rx: 200mW 5,8gHz HobbyKing FPV system 

Please take a look at our Youtube channel. Would help out alot.

- Team EZephyr

Lennart van Maarseveen, Matthijs van Zwieten, Janwillem van Zwieten