"Hair-styling" your servo wires

by btallis | November 19, 2012 | (18) Posted in Tips


In this video, I show how you can make the wiring of your RC aircraft (plane, quad, FPV, etc) look cleaner and more professional by giving the wires a "perm".

I hope you enjoy...

Brad



- Find this article & others like it at www.FliteTest.com -

COMMENTS

Benn Gunn on November 21, 2012
Very entertaining and I learnt something too …… very good
Log In to reply
curound on November 30, 2012
Nice job. Thanks for sharing.
Log In to reply
coffeebean56 on November 25, 2012
Would have liked to see the "after" photos...

Log In to reply
liveyourdreamsRC on November 25, 2012
Cool This might clean up some messes. Thanks
Log In to reply
DULPYPS on December 19, 2012
This is a great tip, I've been doing this since my RC Car days (years ago). It makes your install look nice and neat. I mainly use this technique for my rudder servo on my helis. The cyclic wiring I usually tuck inside the frames.
Log In to reply
jeremy on November 20, 2012
5 stars for the josh bixler part. very funny. oh and the tip is a good one as well.
Log In to reply
Leadbelly on November 28, 2012
I wonder if it will hold twists in the wire to stop RF noise on my FPV setups that is a good one. Thanks
Log In to reply
walrus on January 28, 2013
Great tip and I loved the hair dryer warning "just sayin"
Log In to reply
Bellows on January 18, 2016
Great tip and very nice presentation. Thank You.
Log In to reply

You need to log-in to comment on articles.

btallis

(58)

"Hair-styling" your servo wires