We finally, after building and reparing, managed to get a good first flight out of this beast! Unfortunatelly the GoPro wasn't installed on this flight, neighter was the FPV equipment...
Equipment used:
- Ritewing Zephyr II ( www.ritewingrc.com )
- cameras used (or could be used): GoPro HD Hero 2 ( www.gopro.com ) FPV camera CMOS 720x480 ( http://www.rctechnics.com/camera-cmos-720x480-hd ) ground camera: HTC Desire S
- Motor/ESC: RiteWing Zephyr 2 Motor + ESC Package ( http://shop.righthere.nu/fpv-planes-and-parts/zephyr2-parts-spares/ritewing-zephyr-2-motor-esc-package/prod_1353.html )
- FPV Tx/Rx: 1.2 gHz 800 mw ( http://www.rctechnics.com/partom-1-2ghz-800mw-a-v-transmitter-receiver )
- The rest Hobbyking electronics (direct message for further info)
Rate 5 stars!
thanks,
-TeamEZephyr
Young pilots, lots of experience!
Log In to reply
Log In to reply
Log In to reply
Log In to reply
Log In to reply
Log In to reply
http://www.hamradioshop.nl/index.php?route=product/product&product_id=198 is er een, Team Blacksheep verkoopt ook goeie antennes..
Log In to reply
Log In to reply
Can you please send me a detailed list of parts (especially interested in your FPV cam of choice)
Log In to reply
our FPV cam of choice is the FPV camera CMOS 720x480 camera from RCTechnics it has a great resolution and has a good n stiff metal casing in case of crash, The FPV Tx and Rx are on our Zephyr a 1.2gHz 800mW system of the e-store is Rotterdam, The Netherlands. And on a new prototype wing we designed ourselves we have a 5.8gHz 200mW system of Hobbyking and a 420TVL Sony 1/3 inch CCD cam also from hobbyking. We haven't flown the prototype yet because me (Lennart the owner/designer) have broken my foot and are still recovering but we hope to fly is a.s.a.p. I hove this was enough Information for you.
If it wasn't enoug you can always mail us at TeamEZephyr@hotmail.com or TeamEZephyr@gmail.com
-sincerely TeamEZephyr
Log In to reply
Flight4Life (location: Hilversum ;) )
Log In to reply
- sicerely TeamEZephyr
Log In to reply
Log In to reply
Log In to reply