KK2 voltage alarm tutorial

by dhdsracer | July 7, 2012 | (24) Posted in Tips

This a little hidden feature on the kk2 board that many people don't know about. I hope it help some people out there.


- Find this article & others like it at www.FliteTest.com -

COMMENTS

jamiedco on July 12, 2012
this will be the first mod i do when my kk2.0 arrives
Log In to reply
TimJC on December 5, 2012
Is there a voltage limit for this alarm? Is it limited to 3s or can 4s be used?
Log In to reply
Renceww3 on November 26, 2012
very nice video, too bad it does not flat-line when battery shows 0.0V :P
Log In to reply
FreiGuy on July 9, 2012
This is a very handy video, however the screen on the KK2 board can't be seen whatsoever during the programing portion.
Log In to reply
dhdsracer on July 9, 2012
Yeah, I didn't feel it was too important in the end. Once you have a kk2, it all makes sense.
Log In to reply
Buzz Bomb on July 9, 2012
Nicely done and great information.
Log In to reply
SwiftFootTim on May 8, 2013
If I use this setup, should I cut the power leads from all three ESC's for a tricopter setup?
Log In to reply
x3mperformance on February 24, 2013
As always.
Your tips and videos are "sit back, suck in, learn and enjoy"
Log In to reply
Heckle0 on August 25, 2013
Ok...so I'm thinking about doing this but.... Do i connect the main battery to this new voltage alarm connection? And if so do i need a BEC on the first group of pins like normal still?
Log In to reply

You need to log-in to comment on articles.

dhdsracer

(75)

KK2 voltage alarm tutorial